Fitting Kit - Original Screw Kit


Product Description

This screw kit is easy to use with stainless steel self tapping screws (a screw which can tap its own hole as it’s driven into the bumper material ). (But you must first drill a 4mm hole in the plate with a drill bit). The screw top will be hidden from view with your choice of colour screw cap top (supplied) depending on where in the number plate the screws are placed.

Your screw cap number plate fitting kit will consist of:

  • 4 screws

  • 4 blacks caps

  • 2 yellow caps

  • 2 white caps

Fitting your new registration plate couldn't be simpler. For this you would be required to follow these steps: 

  1. Line up your plate with your old set so you can mark where the holes need to be drilled.

  2. Once you have drawn a mark in the required area with a pen/pencil, you need to use a 4MM drill bit to create the holes.

  3. Line up the first hole with the hole in your bumper. Push a screw through the required screw cap and screw it through both holes, tightening accordingly. 

  4. Repeat this step on the other side. 

Done properly, this will ensure that your plates are not going to come off at any point in the future. If you need more screws and caps, check out our Multipack Fitting Kit. 


Material No